Quantcast
Channel: Axis Communications Firmware
Viewing all articles
Browse latest Browse all 9492

AXIS P5512-E PTZ Dome Network Camera, version 5.25.1

$
0
0
This firmware is now available. Please visit the product's support page on www.axis.com for the download, full release notes and installation instructions.

RELEASE 5.25.1
================
5.25.1 is a production service release for AXIS P5512-E.

Corrections in 5.25.1 since 5.25
================
5.25.1:C01 Corrected the SSP/PPS H264 parameters time stamps,
now it will be the same as the following I-frame.

5.25.1:C02 Socket leak during Guard Tour which caused
the camera to slow down.

5.25.1:C03 Ethernet driver and streaming fixes added,
should correct some cases where the camera was left unresponsive.

Known Bugs/Limitations
================
5.25.1:L01 Motion detection reacts to IR cut filter switching.

5.25.1:L02 Uploading an expired or not yet valid encrypted client certificate in PKCS#12 format for 802.1x will succeed instead of being rejected as it should be.

5.25.1:L03 RTSP clients timeout when syncing unit to computer time due to the keepalive messages being regarded as too old/new depending on the time set.

5.25.1:L04 Errors in log when removing micro SD card without unmounting it first.

5.25.1:L05 Focus can sometimes be poor on the ELMO 401C block.

5.25.1:L06 Criticals found in system log at restart when Guard tour is running.

5.25.1:L07 Control panel is hidden behind the video sometimes. The AMC component is uncontrollable by the web viewer.

5.25.1:L08 After a factory default,the default PTZ home position not defined when the PTZ framework is told to go to the home position; the the camera will remain at the calibration point.

5.25.1:L09 Onvif failing test case 6.2.24. This is due to a bug in the test tool and test specification, i.e. the Axis interpretation is correct.

5.25.1:L10 No warning message in log when pre-trigger buffer is too large.

5.25.1:L11 ONVIF speed param is ignored by the camera.

5.25.1:L12 MJPG recordings to SD card with too high bitrate may cause oom kill of monolith. Lower the bitrate to a rate that the SD card/controller can handle. Can not give specifics since it differs between SD cards.

5.25.1:L13 From time and duration not respected in continuous recording <5 min; Cue points not available and seeking is not possible until a MKV-file is finalized (stopped or full 5 minutes).

Viewing all articles
Browse latest Browse all 9492

Latest Images

Trending Articles



Latest Images