This firmware is now available. Please visit the product's support page on www.axis.com for the download, full release notes and installation instructions.
Improvements in 5.40.9.5 since 5.40.9.4
================
5.40.9.5:I01 Better constant bitrate algorithm.
5.40.9.5:I02 Fix for SD-card corruption.
5.40.9.5:I03 ONVIF stability fixes.
5.40.9.5:I04 New version of libupnp without buffer overflow vulnerabilities.
5.40.9.5:I05 TTL value for always multicast is taken into account.
5.40.9.5:I06 SDP for always multicast available to viewer users.
5.40.9.5:I07 Solved connection issues to AVHS servers.
5.40.9.5:I08 Improved TCP notification stability.
5.40.9.5:I09 Improved stability when using AxisNS.
5.40.9.5:I10 No extra backslash added on a FTP server when using a domainusername scheme.
5.40.9.5:I11 Added support for power line frequency.
Known Bugs/Limitations
================
5.40.9.5:L01 It is recommended to unmount the SD Card before ejecting it.
5.40.9.5:L02 Recordings made with firmware earlier than 5.20 will not be readable
on the SD Card from the 5.40 firmware. Backup important recordings and
reformat the SD Card after the firmware upgrade.
5.40.9.5:L03 Remote back focus operation will be disabled when temperature
is too low. Information will be shown in the system log.
5.40.9.5:L04 Check and repair is only available if the file system is ext4.
5.40.9.5:L05 Recording streams with a total bit rate above
12Mbit/sec to SD Card may cause missing frames/sequences.
5.40.9.5:L06 When using action rule resulting in short recordings, it is recommended
to extend post-event time.
5.40.9.5:L07 With audio enabled, the initial connection latency increases.
5.40.9.5:L08 Sometimes IR cut filter switches between ON/OFF after factory default when
illuminance is 7-10 lux.
5.40.9.5:L09 Color parameter has no effect when pulling RTSP stream with color=0.
Improvements in 5.40.9.5 since 5.40.9.4
================
5.40.9.5:I01 Better constant bitrate algorithm.
5.40.9.5:I02 Fix for SD-card corruption.
5.40.9.5:I03 ONVIF stability fixes.
5.40.9.5:I04 New version of libupnp without buffer overflow vulnerabilities.
5.40.9.5:I05 TTL value for always multicast is taken into account.
5.40.9.5:I06 SDP for always multicast available to viewer users.
5.40.9.5:I07 Solved connection issues to AVHS servers.
5.40.9.5:I08 Improved TCP notification stability.
5.40.9.5:I09 Improved stability when using AxisNS.
5.40.9.5:I10 No extra backslash added on a FTP server when using a domainusername scheme.
5.40.9.5:I11 Added support for power line frequency.
Known Bugs/Limitations
================
5.40.9.5:L01 It is recommended to unmount the SD Card before ejecting it.
5.40.9.5:L02 Recordings made with firmware earlier than 5.20 will not be readable
on the SD Card from the 5.40 firmware. Backup important recordings and
reformat the SD Card after the firmware upgrade.
5.40.9.5:L03 Remote back focus operation will be disabled when temperature
is too low. Information will be shown in the system log.
5.40.9.5:L04 Check and repair is only available if the file system is ext4.
5.40.9.5:L05 Recording streams with a total bit rate above
12Mbit/sec to SD Card may cause missing frames/sequences.
5.40.9.5:L06 When using action rule resulting in short recordings, it is recommended
to extend post-event time.
5.40.9.5:L07 With audio enabled, the initial connection latency increases.
5.40.9.5:L08 Sometimes IR cut filter switches between ON/OFF after factory default when
illuminance is 7-10 lux.
5.40.9.5:L09 Color parameter has no effect when pulling RTSP stream with color=0.